Philco PHWK 2012 User Manual download pdf (Page 7)

PART 3: BEFORE FIRST USE

1. Remove all wrapping material from the kettle and its base.

2. Fill the kettle with clean water up to the maximum water mark. Boil the water and empty the contents of

the kettle. Repeat this process 2 to 3 times.

NOTE:

To boil water in the kettle proceed according to the instructions in chapter Using the kettle.

3. Now the kettle is ready for use and for preparing warm beverages, etc.

PART 4: USING THE KETTLE

1. Set the desired length of the power cord. Push the power cord into the groove in the base. Place the base

on a stable, even and clean surface.

2. Fill the kettle with the required amount of water. You may ﬁ ll the kettle through the spout or through the

opening after lifting the lid. To open the lid, press the safety lid lock 4. The water level must reach at least

the minimum mark (0.5 l) and must not exceed the maximum mark (1.7 l).

WARNING!

Never ﬁ ll the kettle if it is located on the base.

If the kettle is overﬁ lled, then boiling water could splash out.

3. Place the kettle on the base. Insert the power plug into the an electrical power socket. Check that the lid of

the kettle is closed.

4. Start the kettle by moving the switch to position I (On). The power On light will illuminate.

ATTENTION:

Do not turn on the kettle if it is empty. The incorrect use of the kettle may negatively affect its lifetime.

Ifyou accidentally turn on the kettle without water, the thermostat will, after reaching a certain temperature,

interrupt the electric circuit and the power On light will turn off. The kettle can be used again after several

minutes, as soon as its stainless steel bottom has cooled down.

5. As soon as water boils the kettle will turn off automatically and the power On light will turn off. Before taking

the kettle off the base, check that it has turned itself off automatically. If it has not automatically turned itself

off, turn off the kettle manually by moving the switch to position 0 (Off).

NOTE:

The operation of the kettle can be interrupted at any time by moving the switch to position 0(Off).

6. Pour the boiled water into a prepared container, cup or mug. Make sure that the kettle remains in ahorizontal

position when it is carried, particularly if it is ﬁ lled all the way up the maximum mark.

If you wish to open the lid to reﬁ ll the kettle, ﬁ rst empty all the contents from the kettle so that you are not

scalded by the escaping steam.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

No comments

Philco PHWK 2012 User Manual Page 7