Philco PHJE 5020 User Manual download pdf (Page 8)

6) Seat the lid (8) on to the juice

collector (4) so that the outer left

mark

on the lid aligns with the

mark

on the motor unit (2). Then

turn the lid in the clockwise direction

all the way so that the mark on

the lid aligns with the mark (

)

CLOSE (ﬁ g. 6).

Fig. 6

7) Install the ﬁ lling dish (10) on the lid (8)

NOTE:

Only start the appliance when all the removable parts are correctly installed and the lid (8) is in the CLOSE

(

) position.

Using the appliance

Important notices:

Before turning on the appliance, make sure that all the parts are correctly installed. Do not turn on the appli-

ance without the ingredients intended for processing. Fruit, vegetables and berries intended for processing must

always be fresh!

1) Wash the ingredients intended for processing and remove inedible parts such as tough peels, stones, etc.

2) Cut fruit/vegetables into pieces that will easily pass through the hopper of the appliance.

3) Place the juice jug (12) under the spout of the juice collector (4).

4) Insert the power plug into ael. power socket.

5) Turn on the appliance by pressing switch (3) to position I.

Operating modes of the appliance

I– the appliance is turned on

0 – the appliance is turned off.

R – reverse rotation direction. This mode is used in the event that the screw jams, if the appliance is overloaded.

An overload may occur as aresult of processing hard or ﬁ brous foods. To set the reverse rotation direction,

press the switch to the off position “0” and then press and hold the switch in position “R”. Allow the mode

to run for 3 – 5 seconds. If the problem persists, turn off the appliance, disassemble and clean it. Then

reassemble the appliance and continue working.

If the jamming of the screw reoccurs, cut the ingredients into smaller pieces and insert them more slowly

into the hopper.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

No comments

Philco PHJE 5020 User Manual Page 8